Electro & Company is proud to bring you the Latest EC4P V3 High Performance Razor Motor. A high end, direct bolt in motor specifically designed for the razor chassis that's beefier than ever! No more need for modified swing arms or chassis' to get big power.
Key Features
- Razor Chassis Direct Fit
- 11kW Recommended Burst
- Up to 14kW Peak
- 6800 RPM Unloaded @76v Nominal (no flux)
- 4 Pole Pair 60mm Rotor
- Ultra Thin Stator Laminations
- Automotive Grade Hall Sensors
- Water Resistant
- High Temp Windings
- High Temp Magnets
- Stainless Steel Rotor Sleeve (new)
- Hardened Shaft & D-Bore (new)
- High Surface Area Design
- Native Fan Mounts
- 48-108v (13s-30s)
V3 Improvements
Stainless Steel Rotor Sleeve for enhanced high RPM durability & Hardened Motor shaft and D-bore for Increased strength at higher powers and loads.
Lead Times
2-4 Weeks ARO*
Compatibility
MX500, MX650, RSF650 & SX500
Dimensions
5.5x5.5x4.5 inches
GEARING
1:7 to 1:5 Ratio Recommended for 10 inch rear wheel only.
The motor comes with 11t installed, if you would like you purchase additional sprockets you can find them in our Accessories section.
IMPORTANT
- For use with Existing Ultimate Razor Kit Controllers (E&C KVD Model Y & Z) Kelly Bluetooth Dongle is required for setup.
SEE INSTRUCTIONS HERE! <-Click Me!
- Higher Currents and Gearing Changes are required to see the benefit of this motor on Ultimate Razor Kit Hardware!
-
FARDRIVER Controllers are not recommended or supported by E&C.
- DO NOT EXCEED 200 Battery Amps / 400 Phase Amps!
